Beck Magnetic Pulse Generator Experimental Prototype

6. August 2009 by HealingMindN.

For those of you not familiar with this device, Dr. Robert C. Beck provides a guide for building several DIY self help devices for people who prefer to stay independent of the present mainstream healthcare system which is focused on drugs and surgery. One of these items is a magnetic pulse generator.The principle within this magnetic pulse generator being superior to others is that it uses the strobe lamp as a thyratron, or a plasma switch to dump energy into a coil which creates a huge, sudden magnetic flux upon its activation.

The pulsed coil acts as the primary of a transformer and anything conductive nearby (e.g. living tissue) acts as the secondary in which current is induced from the coil’s time varying lines of magnetic flux.

Allegedly, this device has a measurable output several thousand times more powerful than the famous brand name magnetic pulsers on the commercial market. (This is difficult to determine. Most gaussmeters on the market are highly sensitive to low magnetic fields, therefore, a single, time varying magnetic burst causes them to go off the scale, both analog and digital.)

Theoretically, it can neutralize electro-sensitive pathogens and viruses when activated over lymph nodes and organs, especially nerve sheaths that are untouchable via immune system, white cells or injectables.

This may account for the impossibility of curing certain chronic infections via pharmaceuticals, antibiotics, or other presently know conventional treatments (not including electrotherapy such as Rife which is far more sophisticated).

On to the Mod

I’m using a Chauvet mini-flash, CH-730, 120VAC, 9.6W (25W max) strobe light. The circuit had two 22uF Electrolytic Caps rated at 350V which I have replaced with two 330uF Caps rated at 400V.

Click the thumbnail to see a detailed picture of two modified strobe lights. As you see, there is a bit of size difference between the former caps and the new ones. The new ones together are about the diameter of a large double barrel shotgun and I fear they may also have the same amount of power.

The new, larger caps were very difficult to find at this voltage rating. When I found them, I knew they would not be able to fit inside the box. They are stuck on top with hot melt glue which is also used to insulate the contacts.

Fortunately the circuit is fused, but I would like to know what further safety precautions to take. It’s possible that the intense energy could cause something to burn out or explode. I would like to know what kind of shielding or further shunt besides that power resister should be employed.

I have also taken into consideration this pulser should not be left activated. I have taken a further precaution by including an SPST switch activated coil.

Approx. 100 feet of 16 AWG wire is wound on a video cassette reel and housed in a polycarbonate shell. A 6 Amp, 125 V SPST switch is in series with this coil to make manual control easy at the desired site of activation. Between the pulser and the coil, there is an RCA cable (for convenience). Inner conductor and ground have been fused together to act as a large conductor.

Thanks in advance,

Randolph

---

Thanks to Dr. Richard Loyd for giving me the confidence from his experience in these types of devices. Dr. Loyd told me he ended up using 600uF Caps, so my 330uF Caps are relatively medium fare.Besides the project discused at http://www.royalrife.com/superthumpy.htm, he also told me of a more powerful setup using a 12,000 volt neon sign transformer, a 20 pound, 1uF capacitor rated at 10,000 volts, and a spark gap rather than a thyratron (flash tube).All of this goes to a flexible wire rated at 40,000 volts which the subject winds around the affected body part.I guess the source of my fear was the relative size of the caps in comparison with the rest of the circuit. In reality, the part that will wear out first in this configuration is the flash tube.There are sources for more powerful flash tubes, in fact, I’m even considering retrofitting it with a spark plug, which is still basically a high energy plasma switch. I suspect that the more advanced Beck Generators might have this. I could be wrong. The following video is my personal take on building a Beck-type Magnetic Pulser:

For now, I have a 330uF double barrel, modular magnetic pulse generator that has a very nice “thump” to it. The modular system allows different coil configurations. Rather than simple wound solenoids, I plan on more exotic self canceling coils such as mobius, caduceus, and bifilar that have deliver pure potential with parallel magnetic and electric fields rather than the classic force vector of perpendicular magnetic and electric fields.The basis for this is from two classic articles in bioenergetics on the biological effects of Scalar Energy and Quantum Fields wherein scalar and quantum field coil configurations are more efficacious in the healing process.I’m going under the assumption that a Beck Generator is acting as a short impulse multiple wave oscillator. Scalar and “quantum” coil configurations are more efficient with higher frequencies in the megahertz region. Gated square wave pulses through these coil configurations have provided more efficacious healing under controlled experiments.

To this end, I will probably be leaving the Beck magnetic pulse generator behind for more elaborate fare in scalar and quantum fields. For now, I will make this generator available for other experimenters in magnetotherapy in the Beck Protocol. More to come.

P.S. I’ve decided to part with one of my prototypes - Here’s the manual for those who are interested: Beck Magnetic Pulse Generator Manual. I going to sell it on eBay to help finance more advanced projects. Please see my Twitter Profile on my latest offerings at eBay. Thanks for your interest!

Posted in Science Tools, Healing Science | Print | No Comments »

Bioenergetic Diagnostics in Alternative Healing is Personalized

30. June 2009 by HealingMindN.

Utah-based company BioMeridian provides several technologies for bioenergetic testing

BioMeridian™ is a Utah-based company that provides several technologies for bioenergetic testing. Specifically, BioMeridian develops Meridian Stress Assessment (MSA) instruments, including software platforms and acupuncture-point reading devices, for health care practitioners. MSA tests measure energy levels at acupuncture points on the body, and the results of these readings help practitioners evaluate patient health. The goal is to bring areas of imbalance – or poor health – back into stability.

The technologies from BioMeridian are based, in part, on the work of a German doctor, Reinhold Voll, who in the early 1950s discovered how to locate the body’s acupuncture points electronically. Voll was able to show that electrical currents at these points were different from those at surrounding tissues, and further research revealed these electrical readings could be used to diagnose health conditions. An abnormal reading, for example, might indicate lung problems or allergic tendencies. In addition, Voll discovered that certain substances, such as bottles of medicine, produced electro-magnetic frequencies.

Voll’s discoveries contributed to future advancements in bioenergetic medicine, including Meridian Stress Assessment. As mentioned above, MSA systems evaluate energy levels at acupuncture points. The energy measured at these points is thought to flow through human electrical channels, commonly referred to as meridians. Similar to traditional Chinese medicine, it is believed that organs and organ systems are related to the flow of energy throughout the body. Therefore, the discovery of blockages or disturbances in this flow can help health care practitioners identify disorders and provide necessary therapies. An MSA system aids practitioners in suggesting nutritional, enzyme-based, herbal or homeopathic products to support patient health.

One popular bioenergetic testing product from BioMeridian is the MSAS®-Professional. The MSAS®-Professional, an MSA system as indicated by its name, uses an electronic probe to read the energy levels at acupuncture points on the body. This evaluation is read via graphic display on a computer screen and in a printed report. With this information, practitioners can help patients understand how the energy flow in their bodies might be affecting their health. The MSAS®-Professional also provides practitioners with a database of more than 40,000 natural products they can consider for their patients. In addition, practitioners can develop their own protocols and program those into the MSAS®-Professional.

Another bioenergetic testing device from BioMeridian™ is the Vantage™ instrument, which is optimized for BioRep,™ the company’s premier software program. Unlike MSAS®-Professional, the Vantage product does not require a computer. The Vantage, referred to as a bioelectrical impedance measurement (BIM) platform, provides health care practitioners with a quick, affordable way to assess patient health and nutritional needs. The manufacturer claims Vantage has proven itself in clinical trials to offer results in as few as 20 minutes. At no additional charge, BioMeridian includes admission to its Proficiency Training Seminar with the purchase of a Vantage device.

BioMeridian’s EPIC™ probe is integrated for use with the Vantage and MSAS®-Professional products. The EPIC provides accurate, reliable readings of energy flow at acupuncture points on the body. The probe, according to BioMeridian, takes little time to learn and controls for pressure-related variables. Practitioners are required only to place the EPIC’s Sure-Touch® tip on acupuncture points, and the EPIC carries out the measurement.

(SOURCE: BioMeridian International)

Here is a three part video series from conscious.tv featuring detailed patient/doctor/nurse interaction during a BioMeridian analysis for preventive health:

---

---

As you notice, a holistic bioenergetic session is vastly different from conventional medical treatment in that it’s geared towards personal lifestyle in a very detailed way; this is in direct contrast to conventional medicine that treats people like cars in a repair shop which insists on standardized repair for standardized problems. Here’s a summary:

Allopathic vs. Holistic Medicine

Allopathic (mainstream)*	Holistic (personalized)
Classifies people according to disease and provides standardized Treatments of only the obvious symptoms of that disease while ignoring the underlying cause. Is mainly interested in standardized drug treatments of all people that can last from years to a life time.	Roots out the underlying cause of disease by identifying and diagnosing the particular weaknesses and stresses within an individual through detailed analysis. Is mainly interested in lifestyle changes for individuals to keep them from getting ill, thus, preventing the need for long term drug treatment.
*Michael Jackson’s personal mainstream physician caused his relatively early demise because that physician was more interested in serving the drug companies and his medical religion rather than Michael Jackson’s overall health.

Thanks for your time.

Healing Thoughts,

Randolph Fabian Directo

Posted in Bioenergy, Science Tools, Healing Science, Organisations | Print | No Comments »

Book Review: Molecular Bioenergetics

6. June 2009 by HealingMindN.

Molecular Bioenergetics: Simulations of Electron, Proton, and Energy Transfer (Acs Symposium Series)

Molecular Bioenergetics: Simulations of Electron, Proton, and Energy Transfer (Acs Symposium Series)
Manufacturer: An American Chemical Society Publication
Number Of Items: 1
Number Of Pages: 210

All living things rely on the efficient storage, transduction, and use of energy. For example, all free energy used by biological systems originates from solar energy stored by photosynthesis and its effective use relies on its transformation from one form to the other. In this volume, leaders in the fields of computational modeling of electron transfer, proton transfer, proton-couples electron transfer, and energy transduction present new methods for simulating bioenergetic processes and summarize applications to proteins, including the photosynthetic reaction center, bacteriorhodopsin, and cytochrome c.

Posted in Science Tools, biochemistry, Bioenergetic Spectrum | Print | No Comments »